
Injection-moulded PP moulds for casting interlocking paving stones, hollow bricks and decorative cement blocks, quoted at several hundred reuses.
Both moulds in this line cast interlocking units, and the profile is the whole reason for choosing them. A plain rectangular paver or brick sits beside its neighbour with only the joint between them holding the two together. An interlocking profile gives the unit edges that key into the units around it, so the laid surface resists movement as a connected field rather than as separate pieces.
The line covers two different products on that same principle. The big paver mould casts a 200 × 200 mm interlocking paving stone. The HC-B-25 casts a 200 × 200 × 200 mm decorative interlocking hollow cement brick, which is a block for a decorative wall rather than a flat paver for a surface.
These are production moulds, so the number that decides the cost per unit is how many times one mould can be used before it is replaced. The paver mould is quoted at more than 800 reuses. The hollow brick mould is quoted at more than 200 uses and suits frequent, large-scale production rather than occasional casting, with a demoulding time of one to two days.
The paver figure is worth checking at enquiry. RENFA quotes more than 800 times, while the supplier description for the same range cites 1,500 to 2,000 times, so the two numbers do not agree and it is worth confirming which applies to the order in hand rather than assuming the higher one.
Both are PP, chosen for wear resistance in repeated outdoor production, and the paver mould is described by the supplier as using grade EP200k imported from Sinopec. Plastic, rubber, PP or ABS can be supplied on request, and the standard colour is white.
Strength comes from the mix rather than from the mould: with 400# cement the pavers are stated to take a compressive strength of 400 to 500 kg/cm², which is the manufacturer figure rather than a tested value for a particular order. The minimum order for the paver mould is 500 pieces, with logo, packaging and graphics customisable from 1,000 pieces. The hollow brick mould has a minimum of 10 pieces, packed in woven bags with delivery in 7 to 15 days, and size, pattern and packaging can be customised from 100 sets.
More questions are answered on the FAQ page.
RENFA quotes more than 800 times. The supplier description for the same range also cites a reuse life of 1,500 to 2,000 times, so the two figures do not agree and it is worth confirming which applies to your order rather than assuming the higher one.
A 200 × 200 mm interlocking paver. With 400# cement the pavers are stated to take a compressive strength of 400 to 500 kg/cm². That is the manufacturer figure rather than a tested value for a particular order, and it depends on the mix as much as on the mould.
The paver mould casts a 200 × 200 mm interlocking paving stone for a laid surface, quoted at more than 800 reuses. The HC-B-25 casts a 200 × 200 × 200 mm decorative interlocking hollow cement brick for a decorative wall, quoted at more than 200 uses, and its demoulding time is one to two days. They suit different products rather than different budgets.
Both are PP, and the paver mould is described by the supplier as using grade EP200k imported from Sinopec. Plastic, rubber, PP or ABS can be supplied on request, and the standard colour is white.
Tell us the capacity, the power supply you have and the destination port. We will confirm which model in this line fits and quote it with packing dimensions.